The first time I attempted to use the top turret after zeroing the scope and setting the zero stop it made it one revolution and stopped on 23 now it will only move from 23 to 21 any suggestions?
top of page
Log In to Connect With Members
View and follow other members, leave comments & more.
bottom of page
Be sure to loosen the ZeroStop lock and set screws. When you are setting your rifle's zero, back out the lock and set screws, and lock them back down until you are done zeroing the rifle. Once that is done, loosen the (3) perimeter screws around the turret, and set the turret marking back to -0-. Tighten the (3) screws back down. Now, loosen the ZeroStop lock screw. Turn the turret to elevate it by 2 clicks. Turn the ZeroStop set screw down until it makes contact with the internal stop plate. From there, back the set screw out 1 full turn, and tighten the ZeroStop lock screw. From there, you should have a positive stop at the -0- mark, and you are ready to roll!